Autostart AS-6265iSH - Manual (Page 2)

Transmitter Part Number and Module Serial Number
Transmitter Part Number:
The installer is to write in the boxes below the Module’s serial number and the location of
the Valet Switch.
Module Serial Number:
Valet Switch is located (if installed):
Introduction
This Module is a state-of-the-art combination of an Alarm system and a remote car
starter. It represents a major breakthrough in vehicle security technology and remote
starter systems. This unit is distributed with a super-heterodyne antenna with range of up
to 1500 feet / 450 m.
Basic Remote Operation
This system is equipped with a 5-button multi-channel transmitter. It can operate two in­
dependent identically-equipped vehicles (see Multi-Car Operation for second-car
transmitter functions).
User Guide P. 2
Intrusion Codes via LED light
If there has been an intrusion in the vehicle while it was locked and armed, the LED will
provide an intrusion code corresponding to the type of the intrusion which took place. The
LED intrusion codes are flashed in continuous loops. They are the same codes as those
provided during Events Playback:
1 x = Power-up Reset: Battery disconnected / reconnected or dead>
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Multi-Car Operation
This option allows the owner of two vehicles, both equipped with identical systems, to
control both systems with only one remote transmitter. To control the second vehicle,
simultaneously press the trunk button and the button of the function you wish to use:
Press trunk + lock button simultaneously:............. ............. lock
Press trunk + unlock :............................................. ............. unlock
Press trunk + start : ............................................... ............. start
Press trunk + stop :............................................................... stop
Press trunk + lock + unlock :................................. ............. aux 3 ( trunk )
Press trunk + stop for 3 sec:................................................ cold weather mode
Car Finder
When enabled, the Car Finder option will help you locate your vehicle by sending a
pulsating signal through the horn or the siren. To hear the signal, press the lock and
unlock buttons simultaneously. This will produce a pulsating signal for the time you keep
the buttons pressed.
Diagnostics - Chirps Diagnostics - Parking Lights
Chirps Description
1
• Lock and arm the system.
• lock confirmation.
• Entering Mode 1 in the programming options.
• Start attempt when engine is already running under remote control.
2
• Unlock and disarm.
• Transmitter learnt.
•
Entering Remote Valet.
• Entering Mode 2 in programming options.
3
• Lock and arm - a zone is unprotected.
• Entering Mode 3 in the programming options.
4
• Unlock and disarm - an intrusion occurred.
• Entering Tach Learning procedure.
• Entering Mode 4 in the programming options.
5 • Siren or Horn Chirp Timing adjustment.
Constant up to
60 seconds
• In Siren Mode: alarm condition generated by an intrusion, by Panic Mode or when the
Module is powered up. The Siren will sound for 60 sec.
Constant up to
30 seconds
• In Horn Mode: alarm condition generated by an intrusion, by Panic Mode or when the
Module is powered up. The Horn will sound for 30 sec.
P. 11 User Guide