DSC WLS900 - Manual (Page 18)

18
After the test period has ended, the Motion Detector will automatically end its test mode and return
to normal operation. (Later versions of Motion Sensors may stay in “test mode” for 3-4 minutes.)
Questions About Your Walk Test?
If you are ever unsure about testing your system, or if the Walk Test reveals that a Sensor is not working
properly, contact your installer for assistance.
Motion Sensors are trap protection for rooms or areas. They are designed to break the room or
area into small wedges of detection. The best detection occurs while crossing or moving across
the sensors fingers of detection. Discuss your specific protection requirements with your installer
to assure proper detection.
8 SOUNDER FUNCTIONS
The Sounder operates at several different levels to indicate: Intrusion Alarms, Fire Alarms and other
system operations. Many of the sounds the Sounder can produce are programmable by your installer;
your installer will inform you of which sounds have been programmed for which alarms. The possible
alarms and indications from the Sounder are described below:
Event Sound Notes
Entry / Exit Delay Exit Delay: pulsing beeps Your installer will tell you if your
Entry Delay: steady tone Entry/Exit Delay Tone has been
Medium or low volume set for medium or low volume.
Trouble Conditions Double “beep” at medium or This tone is used to indicate that there is
Sensor Faults low volume every 10 seconds a trouble condition on the system. Refer to
Tamper Faults the Trouble Conditions, Sensor Faults and
Tamper Faults Section 5 of this manual.
Fire Alarm Loud pulsing alarm, or Your installer will inform you of how the Fire
Loud steady alarm Alarm will sound on your system
Intrusion Alarm Loud steady or Your installer will inform you if any zones
Loud pulsing alarm, or have been programmed to generate a
Silent silent alarm. Zones set for silent operation
will not cause the Sounder to operate,
but will transmit an alarm to your monitoring
station if programmed to do so.
Key Loud pulsing alarm, or To silence an Key alarm, enter an
Loud steady alarm personal Access Code
Key Silent alarm When the Key alarm is reported
to your monitoring station, the Sounder
will sound a series of beeps.
Key Silent or To silence a Key alarm, enter an
Audible alarm personal Access Code.