DSC WLS900 - Manual (Page 10)

10
5I - System Ready
This message will be displayed when a personal Access Code is entered and
the system is ready to be armed.
5J - Alarms in Memory
If there are alarms in memory, this message will be displayed before arming.
When the Keypad displays this message allowing you to arm the system,
press the
-YES Key to arm the system, or press the -NO Key. To view
alarms in memory, press the -NO Key until the next message is displayed.
Press the -YES Key to view “alarm memory”. Refer to Alarm Memory and
Alarm History in Section 4D for instructions on reviewing alarms in memory.
5K - Bypassed Zones
This message will be displayed if zones on the system have been bypassed.
Refer to Bypassing Zones in Section 6 for information on viewing bypassed
zones.
5L - Trouble Present
A “trouble” is a condition that may cause the system to operate improperly;
refer to the “Trouble Conditions” in Section 5M. When trouble conditions are
reported, they should be investigated immediately. When a trouble condition
is present, the Sounder will beep a warning. Enter your personal Access
Code to silence the trouble indication. When your personal Access Code is
entered, this message will be displayed.
When the Keypad displays a message allowing you to arm the system, press
the
-YES Key to arm the system, or press the -NO Key. To view trouble
conditions, press the -NO Key until the next message is displayed.
Press the -YES Key to view trouble conditions on the system. Your system
may be armed with trouble conditions present, but be aware that the system
may not perform as expected with the troubles present. When viewing
trouble conditions, press the
-YES Key to scroll to the next trouble
condition. When you are finished reviewing the list, press the -NO Key.