Password recovery, Basic commands (read only access), Help (he) or (?) – Datacom Systems VS-1200 User Manual
Page 18
VS-1200 Data Acccess Switch
18
© 2009 Datacom Systems Inc
4.1.2
Password Recovery
Password Recovery is provided for cases where a user has forgotten the Superuser and/or
Administrator login password. Password recovery is accomplished by connecting to the unit serially
using a HyperTerminal like program and rebooting the unit. As the power-up sequence is occurring,
depress
displayed prior to the prompt. This key is used to reset the passwords. An example recovery key
prompt is: 617A6185774$
You must call Datacom Service Center with this recovery key in order to obtain the required
response to reset passwords. Given a valid reset response, the factory default passwords will be
saved in Non-Volatile memory. If an invalid response is given, a new recovery key will be calculated
and displayed at the prompt, as described above, after first clearing the screen.
4.1.3
Basic Commands (Read Only Access)
The following section shows the long form of the basic command set with the shortcut input for the
command noted in parenthesis. All commands, either the exact long form or the shortcut form, are
entered after the prompt (default >) at the cursor. No auto-fill mode is available. After the topic
heading, a brief overview of the command display function is given followed by an example
(Example: >) command input.
4.1.3.1
HELP (HE) or (?)
When this command is entered, a list of commands, their shortcut inputs, and their descriptions will
display. For the use and application of each command, refer to the individual command description
within this section. The HELP command displays the available commands as shown:
Example: > ?
Available commands:
HELP
HE / ?
Show Help
EXIT
EX
Exit Shell
SHOW
SH
Show All Current Configurable Values
SHOW PRODUCT
SH PR
Show Product Name and Serial Number
SHOW TIME
SH TI
Show System Date and Time
SHOW MANAGEMENT
SH MA
Show Management Configuration
SHOW PORT CONFIG
SH PO CO
Show Port Configuration
SHOW PORT ROUTING
SH PO RO
Display Routing Summary
SHOW GROUPS
SH GR
Show Group Configuration
SU
SU
Enter Superuser Mode
SU SET PASSWORD
SU SE PA
Set Superuser Password
SHOW USERS
SH US
Display Users
SET IP
SE IP
Set IP
SET SUBNET
SE SU
Set Subnet Mask
SET GATEWAY
SE GA
Set Default Gateway
SET PROMPT
SE PR
Set Command Prompt (max 32 bytes)
SET DATE
SE DA
Set System Date
SET TIME
SE TI
Set System Time
SET PORT NAME
SE PO NA
Set Port Name (max 32 bytes)
SET PORT SPEED
SE PO SP
Set Port Speed