Datamax Allegro 2 User Manual

Page 64

Creating Labels Using Internal Batch Software

Allegro2

Copy Module:

Copies graphic images and/or label
formats from one memory module to
another. Be certain that the Write Protect
Switch is ‘on’ for the source module and
‘off’ for the destination module.

Metric:

Each time the number 3 is pressed, the
screen will toggle between Metric ‘No’
and Metric ‘Yes’.

Print Test Label:

Prints a Printhead Test Label and is used
as a relative gauge of Printhead condition
and wear.

System Test Label:

Lists all current Printer settings and
checks both ROM and RAM. Prints a
Printhead Test Label after the system test.

Edit Module Name:

This will allow you to change the name of
the module.

Reset Printer:

This is the same as the
Command in the standard Printer Mode.
If switch 7 is on than the Internal Batch
will take over.

Exit To RS-232 System:

This is the same as turning Switch 7 ‘off’
and resetting the Printer. You can use the
command to enter the Internal
Batch without using switch 7 in the rear
of the Printer.

Pack Module Data:

All the label formats are stored in a 256K
Flash Module; therefore, only the entire
Module can be cleared. For this reason,
the data will occasionally need to be
packed from time to time when the
memory becomes low.