Directed Electronics 335912 359D User Manual

Page 33

3. T

Trraan

nssm

miitt.. While holding the Program

switch, press the button on the transmitter

that you would like to control the selected

receiver channel.

4. R

Reelleeaassee.. Once the code is learned, the

Program switch can be released.

You can advance from programming one channel to another by

releasing the Program switch and tapping it to advance steps and

then holding it. For instance: You have programmed Channel

One and you want to program Channel Two. Release the

Program switch. Press it one time and release it to advance from

Channel One to Channel Two. Now, press and hold the

Program switch. The LED will flash two times. As before, do not

release it.

If you want to program Channel Three after programming

Channel One, release the Program switch, press it twice and

release it to advance to Channel Three. Then press it once more

and hold it. The LED will flash three times to confirm it is ready

to receive the code from the transmitter.

Learn Routine will be exited if:

➤

Ignition is turned off.

➤

Program switch is pressed too many times.

➤

More than 25 seconds elapses between programming steps.