Directed Electronics 335912 359D User Manual

Page 30

step 10

Testing the system

Once steps 1-9 have been completed, the operation of the

system can be tested.

Place the two 30-amp fuses back into the relay satellite RED

wire fuse holders. Make sure that the vehicle is in park with the

emergency brake on and the hood closed. Press

and

the remote control simultaneously to initiate the remote start

function. The parking lights should flash to confirm the remote

start command has been received, The accessories and ignition

should turn on followed by the starter cranking and the vehicle

engine running. Pressing

and

again simultaneously will

shut the engine off.

ttrra

nssm

miitttte

err ffu

cttiio

nss

The receiver uses a computer-based learn routine to learn the

transmitter buttons. This makes it possible to assign any specific

transmitter button, or combination of buttons, to any receiver

function. The transmitter initially comes programmed in the

Standard Configuration, but may also be customized by an

authorized dealer. Unless otherwise specified, the buttons used

in all of the instructions in this manual correspond to a Standard

Configured transmitter.

➜