Directed Electronics 335912 359D - Manual (Page 32)

29 © 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
ttrra an nssm miitttte err//rre ec ce eiivve err lle ea arrn n rro ou uttiin ne e
The system comes with one transmitter that has been taught to
the receiver. The receiver can store up to 4 different transmitter
codes in memory. Use the following learn routine to add trans-
mitters to the system or to change button assignments if desired.
The Program switch, plugged into the blue port, is used for program-
ming. There is a basic sequence of steps to remember whenever
programming this unit: Key, Choose, Transmit and Release.
1. K Keeyy.. Turn the ignition to the ON position.
2. C Ch hoooossee.. Within 10 seconds, press and
release the Program switch the number of
times corresponding to the desired channel
listed below. Once you have selected the
channel, press the switch once more and hold
it. The LED will flash to confirm the selected
channel. Do not release the Program switch.
C Ch haan nn neell n nu um mb beerr F Fu un nccttiioon n
1 Lock/Unlock
2 Timer Mode
3 Remote Start