Dayton portable oil-fired heaters – Dayton 3E359B User Manual

Page 10

Dayton Operating Instructions and Parts Manual

Dayton Portable
Oil-Fired Heaters

3E358B and 3E359B

PUMP PRESSURE ADJUSTMENT FOR
HEATERS WITH FUEL FILTER INTER-
NAL TO PUMP

1. Remove pressure gauge plug from

fuel pump port marked “GAUGE.”

2. Install accessory pressure gauge (part

number 110380-01) to fuel pump
port marked “GAUGE” (See Figure
20). Do not use bleeder valve port to
check pressure. Bleeder valve port
contains pressure higher than
operating pressure. Setting pump
pressure with gauge in bleeder valve
port will result in wrong operating
pressure.

3. Start heater (See Operation, page 5).

Allow motor to reach full speed.

4. Adjust pressure. Use small flat blade

screwdriver to turn slotted screw at
fuel pump port at top right side of
pump. Turn screw clockwise to
increase pressure. Turn screw
counterclockwise to decrease
pressure. See specifications below
for correct pressure for each model.

5. Stop heater (See To Stop Heater,

page 6).

6. Remove pressure gauge. Replace

pressure gauge plug in fuel pump
port marked “GAUGE.”

Part

Kit

Number

Flame-Out Control

HA3003

Spark Plug

HA3012

MAINTENANCE KITS

psi

Pressure
Gauge

Pressure
Adjustment
Port

Fuel Pump
Port Marked
“GAUGE”

Pump

Model

Pressure

Model 3E358B

100 psi

Model 3E359B

110 psi

Figure 20 - Adjusting Pump Pressure

PUMP PRESSURE ADJUSTMENT FOR
HEATERS WITH FUEL FILTER/CANIS-
TER EXTERNAL TO PUMP