Dayton 3E359B - Manual

Operating Instructions & Parts Manual
Dayton Portable
Oil-Fired Heaters
®
Form 5S2514
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
3E358B and 3E359B
Version B - For Reduction G016.J
®
Figure 1 – Model 3E358B Figure 2 – Model 3E359B
ARL LOGO G 004
®
1. Remove all protective packing
applied to heater for shipment.
2. Remove heater from shipping
container.
3. Check heater for any shipping
damage. If heater is damaged,
promptly inform dealer where you
bought heater.
Unpacking Description
Dayton Models 3E358B and 3E359B are 350,000 Btu/Hr heaters and 600,000 Btu/
Hr heaters, respectively. These heaters use only Kerosene or No. 1 fuel oil for
combustion and electricity to run the motor. They are primarily intended for well
ventilated indoor or outdoor temporary heating of buildings under construction,
alteration, or repair (Read General Safety Information section carefully). They
may be used in agricultural, industrial, and commercial environments. Products
of combustion are vented into the area being heated.
Printed in U.S.A.
03430
0602/094/VCPVP
General Specifications
Model 3E358B Model 3E359B
Output Rating ......................................... 350,000 Btu/Hr 600,000 Btu/Hr
Amperage at 120V 60 Hz ....................... 7.1 11.0
Fuel .......................................................... Kerosene or No. 1 fuel Kerosene or No. 1 fuel
Fuel Tank Capacity .................................. 30.0 U.S. Gallons 36.0 U.S. Gallons
Fuel Consumption .................................. 2.5 U.S. Gallons/Hr 4.0 U.S. Gallons/Hr
Motor ....................................................... 1725 RPM 1725 RPM
Hot Air Output (CFM) ............................. 1,350 3,300
Fuel Pump Pressure ................................ 100 psi 110 psi
Heater Weight with Fuel ....................... 390 Lb 550 Lb
Heater Weight without Fuel .................. 180 Lb 285 Lb
Spark Plug Gap ....................................... .075 inches .075 inches