Audiovox TRAN-410A - Manual (Page 10)

5. Recall or dial the phone number to be called.
Press |RCL| , then enter the memory address (01
through 50) to recall the phone number to be
called.
1 1 ! 2 ! 3 1 4 1 5 6 7 8 g o
6. Press |SND| . The IN USE | indicator will light as
the call is placed. Link 1 1 will appear on the
readout.
L i n k 1
1 1 1 7 1 4 1 63 4 7 9
=
7. After you received an answer from the long dis­
tance service office, press [SN§ again. The DTMF
signal will be placed and the DTMF tone of your
ID number can be monitored through the
loudspeaker. | Link 2] will appear on the readout.
8. If your ID number is accepted, the long distance
service office will answer again, so press |SND|.
Then the long distance call will be placed and the
DTMF tone can be monitored through the
loudspeaker.
I
Link
3
] will appear on the readout.
SCRATCH-PAD DIALING
This feature permits you to enter a number to be
redialed (or store a number in memory ) while
engaged in a conversation.
SCRATCH-PAD DIALING
WITHOUT KEYING TONES
This feature permits you to acth'ate scratch-pad
memory without annoying key tones over the circuit.
1. Press iFUNCj , then key , then enter a phone
number. |
Tone
| will be displayed for 5 seconds.
The Microphone circuit will remain active, but
the tones will not be heard.
2. If necessary, press
|STO|
, then enter the memory
address.
3. To exit the Scratch-pad Mode, press |FUNC| ,then
key again or turn the unit off.
CALL TIME DISPLAY
This feature automatically records the elapsed time
per conversation. The talk time of the last call,
cumulative talk time, and the number of calls can be
displayed on the readout.
The timers can also be cleared if necessary.
With beep tones you can be notified of the approxi­
mate talk time (NAM Option) in approximately 60
second increments.
To Display the Talk Time of the Last Call
1. Press |RCL| , key then
¡T] .
The talk time of the last call will be displayed on
the readout for 5 seconds.
While in a conversation, the talk time of a call in
progress will be displayed, and updated each sec­
ond. The display format is as follows.
|01 m25|
-1 min. and 25 sec.
To Display the Cumulative Talk Time
1. Press [RCL|, key then
.
The cumulative talk time will be displayed on the
readout in minute format for 5 seconds.
I 1 Srrj •••18min.
To Display the Number of Calls
1. Press !RCy , key
M
then .
The number of calls will be displayed on the
readout for 5 seconds. The display format is as
follows.
I 86c
] •••Received or placed 86 calls
To Clear the Timer
then enter the three-digit security Press |CLR|
code.
2. Press |STO| , key ^ then
[T] .
The timers will be cleared, and the count for the
cumulative talk time and the number of calls will
start from zero.
One Minute Beep (NAM Option)
During conversation, you can be notified of the
approximate talk time by tones for the first five
minutes (a short monotone signal will sound every
minute and a double beep tone will be heard after
approximately 5 minutes.)
18 19