Q troubleshooting – Beko HII 64400 AT User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Q Troubleshooting
Product etnite mertal noises w^ile heating and cooling.
When the metal parts are heated, they may expand and cause noise. This
is not a fault.
Product does not operate.
The mains fuse is defective or has tripped. »> Check fuses in the fuse box.
If necessary, replace or reset them.
If the display does not light up when you switch the hob on again. »>
Disconnect the appliance at the circuit breaker. Wait 20 seconds and then
reconnect it.
Product is not plugged into the (grounded) socket. »> Check the plug
connection.
Overheat protection is active. »> Allow your hob to cool down.
The cooking pot is not suitable. »> Check your pot.____________________
y" symbol appears on the cooking zone display.
You have not placed the pot on the active cooking zone. »> Check if there
is a pot on the cooking zone.
Your pot is not compatible with induction cooking. »> Check if your
cooking pot is compatible with induction hob.
The cooking pot is not centered properly or the bottom surface of the pot is
not wide enough for the cooking zone. »> Choose a pot wide enough and
center the pot on the cooking zone properly.
Cooking pot or cooking zone is overheated. »> Allow them to cool down.
Selected cooking zone suddenly turns off during operation.
Cooking time for the selected cooking zone may be over. »> You may set
a new cooking time or finish cooking.
Overheat protection is active. »> Allow your hob to cool down.
An object may be covering the touch control panel. »> Remove the object
on the panel.__________________________________________________
The pot does not get warm even tf the cooking
zone
Is on.
Your pot is not compatible with induction cooking. »> Check if your
cooking pot is compatible with induction hob.
The cooking pot is not centered properly or the bottom surface of the pot is
not wide enough for the cooking zone. »> Choose a pot wide enough and
center the pot on the cooking zone properly.__________________________
Consult the Authorised Service Agent or the dealer where you have
purchased the product if you can not remedy the trouble although you have
implemented the instructions in this section. Never attempt to repair a
defective product yourself.
25 I EN