beautypg.com

For single-phase connection, For double-phase connection – Beko HII 64400 AT User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Type label is at the rear housing of

the product.

• Power cabie of your product must

comply with the values in

"Technicai specifications" table.

^ Risk of electric shock!

Before starting any work on the

eiectricai installation, please
disconnect the appiiance from

the mains supply.

Connecting the power cable

1. If it is not possible to disconnect all

poles in the supply power, a

disconnection unit with at least 3

mm contact clearance (fuses, line

safety switches, contactors) must

be connected and all the poles of

this disconnection unit must be

adjacent to (not above) the product

in accordance with lEE directives.
Failure to obey this instruction may

cause operational problems and

invalidate the product warranty.

Additional protection by a residual

current circuit breaker is

recommended.
If a cable is supplied with the
product:

LU2

2. For single-phase connection,

connect the wires as identified

below:

Brown/black cable = L (Phase)

Blue/grey cable = N (Neutral)

Green/yellow cable = (E)

(Ground)

3. For double-phase connection,

connect the wires as identified

below:

Brown cable = L1 (Phase 1)

Black cable = L2 (Phase 2)

Blue/grey cable = N (Neutral)

Green/yellow cable = (E) “

(Ground)

Installing the product

H If it is possible to touch the

bottom of the product since it is
installed onto a drawer, this

section must be covered with a

1 min. 48 mm

m When installing the hob onto a

cabinet, a shelf must be installed

in order to separate the cabinet

from the hob as illustrated in the

above figure. This is not required
when installing onto a built-in
oven.

2N AC 380-415 V

IN AC 220-240 V

10| EN

This manual is related to the following products: