Beko HII 64400 AT User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

If the oven is below:
It is required to ieave a ventiiation
opening of minimum 180 cm^ at the
rear section of the furniture as
iiiustrated in the foiiowing figure.
If the board is below:
mm.
** Min. 48 mm
During instaliation of your induction
hob, piace the product parailei to the
instailation surface. Aiso, apply sealing
gasket to the parts of the hob
contacting the counter as described
below in order to prevent any liquid
from penetrating between the product
and the counter.
1. Prepare the surface of the counter
as shown in the figure.
2. Apply the sealing gasket provided
with the product to the edges of the
hob's lower housing that contact
with the counter as illustrated in
figure.
3. Center the product in the counter.
4. Using the installation clamps
secure the hob by fitting through
the holes on the lower casing.
1
Hob
2
Installation clamp
3
Counter
» Rear view (connection holes)
11 I EN