Canon LV-X6 - Manual (Page 59)

50
5. Using On-Screen Menu
[Version]
[Firmware version]
[Data version]
ᕨ Menu Descriptions & Functions [Reset]
Resetting settings and adjustments [Reset]
The Reset feature allows you to change adjustments and settings to the factory preset for a (all) source (s) except the
following:
[Current signal]
Resets the adjustments for the current signal to the factory preset levels.
The items that can be reset are: [Image mode], [Brightness], [Contrast], [Sharpness], [Color level], [Color balance],
[Aspect], [Horizontal position], [Vertical position], [Clock], [Tracking] and [Noise reduction].
[All data]
Reset all the adjustments and settings for all the signals to the factory preset.
All items can be reset except [Language], [Communication speed], [Password], [Remaining lamp time], [Lamp
counter], [Filter counter] and [Projector usage].
Clearing Lamp Hour Meter [Lamp counter]
Resets the lamp clock back to zero. Selecting this option displays submenu for a confirmation. Select [Yes] and press
the OK button.
NOTE:Elapsed time of the lamp use will not be affected even when [Reset] is done from the menu.
NOTE: The projector will turn off and go into standby mode after 2100* hours (up to 3100* hours in Quiet mode) of service. If this
happens, press the INFO button on the remote control for ten seconds to reset the lamp clock back to zero. Do this only after
replacing the lamp. * LV-X6: 3100 hours (up to 4100 hours in Quiet mode).
Clearing the Filter Usage Hours [Filter counter]
Resets the filter usage back to zero. Selecting this option displays submenu for a confirmation. Select [Yes] and press
the OK button.
NOTE: Elapsed time of the filter use will not be affected even when [Reset] is done from the menu.