Vermont Casting VCS4005 - Manual (Page 12)

Control Functions
PROPANE TANK VALVE
WARNING: Never open the Tank Valve unless the Grill is being prepared for use, to prevent the pooling of
propane vapor.
Always open the Valve immediately before lighting the Grill, and always close it immediately after cooking
has been completed.
BURNER CONTROL VALVES
(see Fig. 7)
On Model VCS3505, three valves independently control gas flow to each burner, as indicated on the front
Control Panel.
On Model VCS4005, four valves independently control gas flow to each burner, as indicated on the front
Control Panel.
On Model VCS5005/5010, there are five independent control valves for the main burners, and a separate
control valve for the rotisserie burner.
On Model VCS6005, there are six independent control valves for the main burners, and a separate control
valve for the rotisserie burner.
The OFF position is indicated above each knob. A full range of flame adjustment is available from High to
Low, (by turning a knob counterclockwise).
Activating the Igniter
ELECTRONIC IGNITION SYSTEM
As you push and hold the Igniter Button, you will hear a series of clicks as the igniter module generates an
ignition spark to the burners. The burner should light within five seconds. Depending on which model you
have, the system is powered by either a single “AA” or a single “AAA” battery. To remove or replace the
battery, turn the push button knob counter-clockwise, and carefully pull out the spring and battery. Ensure
that the positive end of the battery is in the down (bottom) position before replacing the knob.
PIEZO IGNITION SYSTEM
As you turn the Igniter Knob clockwise, you will hear a click as the Piezo module generates an ignition
spark to the burner. Rotate the Igniter Knob until the burner lights. The burner should light within five
seconds.
Operation
Page 6
Fig. 7
Rotisserie Burner Control
(if so equipped)
Igniter Button
(All Models)
Main Burners
(3, 4, 5, or 6 )
(VCS5005/5010 Model Shown)