Battery insertion method, Battery detachment method – Audiovox CDM3300 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Battery Insertion Method

As shown in picture 0, insert the battery to fit into the
groove at the bottom of the handset.

Then press in the direction of ® until it snaps.

• The

battery must be comctiy placed in the battery compaitmenL If the battery is

incotiBctly inserted, the handset will not turn on or the battery may slip out.

Battery Detachment Method

Push the handset separation tab 0 with one hand and pull
in the direction of (2) to separate.

• The battery is not charged when you purchase the product. Use the battery

only after it is fully charged.

• Charge your battery when the battery low-voltage alarm sounds.

Power Connection

Connect the charger to a standard

120V AC outlet.

LED’s will blink orange when the
power is connected.

Charging the battery Only

To charge the battery only, insert the
battery pack into the charger.

LED will indicate charging status.

• Red indicates charging.

• Green indicates charging is complete.

■ Battery is not charged when you purchase he pioducL

• Fully'charge the battery before use.

Charging the Battery with the Handset

To charge the battery with the handset,

insert the handset into the charger.

■ Charging the battery with the handset on is less efficient than charging it with the

handset off.