Operation, Tilling – Bolens 247.29773 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
TO START ENGINE:
1. CAUTION: BE SURE NO ONE IS STANDING
IN FRONT OF THE TILLER WHILE THE EN
GINE IS RUNNING OR BEING STARTED.
2.
Place the shift lever in
position. See figure 17.
the neutral (N)
■
Move the throttle control lever forward to
START POSITION. See figure 18.
Stand at side of the tiller, grasp the starter
handle and pull out rapidly. Return it slowly
to the engine. Repeat as necessary.
NOTE
If engine is warm, start with the con
trol in the “START” position. Chok
ing may not be necessary. See fig
ure 18
/
Choks
Knob
FIGURE 17.
3. Choke Engine. Pull choke knob out to choke
engine. See figure 17. Once the engine starts,
push in the choke knob.
Neutral "N'
Stop
/
Start
\
FIGURE 18.
FIGURE 19.
6. Move the throttle control to SLOW when
transporting the tiller. When the tiller is
being moved to or from the garden, the depth
should be pivoted forward until it engages the
drag stake retainer clip. The machine may be
moved under its own power, without seriously
damaging grass areas as long as it is allowed
to move freely. If the operator holds back, it
will start to dig.
TILLING
1. Adjust drag stake by removing clevis pin and
hair pin cotter, changing stake position, then
replacing hair pin cotter and clevis pin. See
figure 15.
A. Lowering the drag stake will slow the
tiller and make it till deeper.
B. Raising the drag stake will allow the
tiller to move faster and till shallower.
10