Tool operation, Switch, Blade replacement – Black & Decker 3382 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Figure 2

(12.7 mm)|«.

2-3/8"

(60 mm)

(flat biscuits) #20

3/8"

(9.5 mm)|**

2-3/16"

(56 mm)

5/16"

(8 mm

1-13/16"

(46mm)

#10

Figure 3

EDGE TO EDGE JOINT

~1 r~

I——

EDGE

MITRE

JOINT

CORNER

JOINT

OFFSET

TOOL OPERATION

OFFSET JOINT

Switch

Your plate joiner has a trigger switch located on the underside, as shown in

Figure 1 A. To turn the tool on, depress the trigger. To turn the tool off, release

the trigger. To lock the tool on for continuous operation, there is a lock on but

ton located at the rear of the tool just above the cord. When cutting always

hold the tool with one hand on the switch handle and one hand on the auxil

iary handle. To lock the tool on, depress and hold the trigger as you depress

the lock button. Hold the lock button in as you gently release the trigger. The

tool will continue to run. To turn the tool off from a locked on condition,

depress and release the trigger once.

Blade Replacement

In time your saw blade will wear out and need replacement. To remove the

blade, follow the steps below.

1. TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.

2. Remove the 4 torx head screws from the bottom of the shoe, using the

T20 torx screwdriver provided.

3. Rotate the shoe out of the way.