Black & Decker 9400 - Manual (Page 9)

Accessories
The accessories in this manual
are recommended for use with your
Drill Press. The use of any other
accessories or attachments may be
hazardous.
Use^^he accessories listed only
in the sizes specified.
When using any of these
accessories with your tool, be sure
to wear safety glasses. See safety
instructions 9 & 10 on page 3 of this
manual.
Twist Bits
Up to 1/2" diameter
Hole Saws
Up to 2-1/2" diameter
Spade Bits
Up to 1-1/2" diameter;
1-1/2" thick
Wire Brushes
Up to 4" diameter
Sanding Discs
Up to 5" diameter
Sanding Drums
Up to 2-1/4" diameter
Buffing Wheels
Up to 4" diameter
Replacement Chucks and
Chuck Keys are available at Black &
Decker Service Centers only.
The accessories listed in this
manual are available at extra cost
from your local dealer or Black &
Decker Service Center. A complete
listing of service centers is packed
with your tool.
If you need assistance in
locating any accessory, please
contact:
Black & Decker (U.S.) Inc.
Consumer Service Department
626 Hanover Pike
P.O. Box 618
Hampstead, MD 21074-0618
Important
To assure product safety and
reliability, repairs, maintenance and
adjustment should be performed by
Black & Decker Service Centers or
other qualified organizations, always
using Black & Decker replacement
parts.
Extension Cords
Tools that have 3-wlre cords requiring grounding must only be used with
extension cords that have 3-prong grounding type plugs and 3-pole recep­
tacles. Only round jacketed extension cords should be used, and we recom­
mend that they be listed by Underwriters Laboratories (U.L.). If the extension
will be used outside, the cord must be suitable for outdoor use. Any cord
marked as outdoor can also be used for indoor work. (The letters “WA” on the
cord jacket indicate that the cord is suitable for outdoor use.)
An extension cord must have adequate wire size (AWG or American Wire
Gauge) for safety, and to prevent loss of power and overheating. The smaller
the gauge number of the wire, the greater the capacity of the cable, that is 16
gauge has more capacity than 18 gauge. When using more than one exten­
sion to make the total length, be sure each individual extension contains at
least the minimum wire size.
To determine the minimum wire size required, refer to the chart below:
CHART FOR MINIMUM WIRE SIZE (AWG) OF EXTENSION CORDS
NAMEPLATE TOTAL EXTENSION CORD LENGTH-FEET
RATING-AMPS 25 50 75 100 125 150 175 200
0-10.0 18 18 16 16 14 14 12 12
10.1-13.0 16 16 14 14 14 12 12 12
13.1 - 15.0 14 14 12 12 12 12 12 .—,
Before using an extension cord, inspect it for loose or exposed wires,
damaged Insulation, and defective fittings. Make any needed repairs or
replace the cord if necessary. Black & Decker has extension cords available
that are U.L. listed for outdoor use.