Autostart AS-6270 - Manual (Page 7)

Open Zone Notification:
(Off by default.) This feature will warn the user when a Door is left open: upon the
arming of the Module, a 10-sec. notification delay will take place, after which the Siren
will chirp 3 times if an open door is detected.
Ignition-Controlled Door Locks
This is an added security feature. If your system was installed with the Ignition-Controlled
Door Locks option, the doors will automatically be locked as soon as the key is turned to
the IGNITION ON (RUN) position while the brakes are pressed. When the key us turned to the
OFF position, the doors will automatically be unlocked.
Ignition Re-Lock
When the Ignition-Controlled Door Locks option is enabled and the ignition is on , should
any door be unlocked and opened, all the doors will be re-locked next time the brake
pedal is pressed.
Secure Lock
This is an added security feature. If your system was installed with the Secure Lock
option, it will automatically lock your doors and arm the system 4 seconds after your start
your car by remote. The system will automatically lock the doors again after shut-down.
Remote Trunk Release
If your system was installed with the Remote Trunk Release, you can open your trunk by
pressing the
trunk button for 3 sec. on the transmitter, or by pressing the trunk button
twice within 3 sec.
Starter Kill
This added security feature will immobilize your vehicle when the system is armed. If
your system was installed with the Starter Kill option, you will not be able to start your
vehicle with the key unless the system has been disarmed first.
The Starter Kill option follows the Alarm arming function, and can therefore be
programmed to be active (will not arm automatically) or passive (will arm automatically).
In passive Mode, the Starter Kill can be set to arm automatically in 30 seconds either
with or without Siren chirps.
To disarm the Starter Kill, press and hold the
unlock button on the transmitter. The
parking lights will flash twice. (If door locks were installed, this will also unlock the doors.)
In passive Mode, the system will automatically re-arm itself 30 seconds after unlocking
the doors if the key has not been inserted in the ignition by then.
To arm the Starter Kill, press and hold the
lock button on the transmitter. The parking
lights will flash once. (If the door locks were installed, this will also lock the doors.)
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after
the user leaves the vehicle: the unit will take over the vehicle and keep it running for 60
seconds (or until it is shut down by remote control), then shut down the engine and set
the Remote Car Starter to Ready Mode.
Follow all steps of the Ready Mode routine, to activate Turbo Mode:
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and release the brake
P. 10 User Guide
Go ON then off ; then
Flash twice, pause; then
Flash twice again.
Panic Mode
Safety feature: Activate Panic Mode in an emergency situation.
In an emergency situation, you can activate Panic Mode using the lock or unlock or stop
button. This will:
Shut down the engine, Disarm the Starter Kill and
Unlock the doors (if unlock is Activate the siren for 1 minute.
pressed) (See below for a description of the Starter
Or lock the door (if lock is pressed), Kill.)
To activate Panic Mode
Press and hold the stop button for approximately 3 seconds until the siren starts to sound
and the parking lights flash
Or press and hold the unlock button for approximately 3 seconds until the siren starts to
sound and the parking lights flash: this will unlock the doors before the siren sounds.
Or press and hold the lock button for approximately 3 seconds until the siren starts to
sound and the parking lights flash: this will lock the doors before the siren sounds.
Panic Mode will automatically shut down after 1 minute.
Note: To stop Panic Mode before the 1-minute delay, press the lock or unlock button until
the siren stops.
Quick Lockout' M
(Also called Secure Panic.) For fast protection, the system will lock all doors when you
press the brake pedal while the siren is sounding. (Quick Lockout is only available
when Panic has been activated.)
Cold Weather Mode
Ready mode should be set before entering Cold Weather. When the Cold Weather Mode
is active, the engine starts every 2 hours and runs for 3 minutes (or for 8 or 20 minutes
with Diesel engines); the routine will go on for a period of 24 hours.
To enter Cold Weather Mode:
Press and hold the start button for 3 seconds until the parking lights flash 3 times.
(If Safe Start is enabled, the start button must be pressed beforehand - see below.)
To enter Cold Weather Mode if Safe Start has been activated:
Press and hold the start button for 3 seconds until the parking lights flash 3 times.
To exit Cold Weather Mode, do any one of the following:
Open the hood.
Start the engine using the remote control.
Turn the ignition key to the
ignition on ( run ) position.
Press and hold the start button for 3 seconds. (The parking lights will flash once.)
To check whether Cold Weather Mode is active, press and release the brake pedal: the
parking lights should stay on while your foot is on the brake pedal.
User Guide P. 7