Autostart AS-6270 - Manual (Page 5)

Diagnostics - Chirps Diagnostics - Parking Lights
Chirps Description
1
• Lock and arm the system.
• LOCK confirmation.
• Entering Mode 1 in the programming options.
• Start attempt when engine is already running under remote control.
2
• Unlock and disarm.
• Transmitter learnt.
• Entering Remote Valet.
• Entering Mode 2 in programming options.
3
• Lock and arm - a zone is unprotected.
• Entering Mode 3 in the programming options.
4
• Unlock and disarm - an intrusion occurred.
• Entering Tach Learning procedure.
• Entering Mode 4 in the programming options.
5 • Siren or Horn Chirp Timing adjustment.
Constant up to
60 seconds
• In Siren Mode: alarm condition generated by an intrusion, by Panic Mode or
when the Module is powered up. The Siren will sound for 60 sec.
Constant up to
30 seconds
• In Horn Mode: alarm condition generated by an intrusion, by Panic Mode or
when the Module is powered up. The Horn will sound for 30 sec.
P. 12 User Guide
Driving Off
With the vehicle running under remote control, press the unlock button to disarm and
UNLOCK the doors. Enter the vehicle and do the following:
Turn the ignition key to the
ignition on ( run ) position. (Do not turn the key to the Start
position while the engine is running. This will cause the starter motor to re-engage.)
Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no
Key in the Ignition Switch) while the engine is running. For example, if you stop for a
delivery or at a convenience store, lock your vehicle and leave it running for the length of
a run cycle while you are away.
The engine will go on running until the user re-enters the vehicle or until the expiration of
the Engine Run Time.
Idle Mode can be activated through the same routine as that used for Ready Mode; at
the last step, the trunk button is pressed instead of the other buttons:
1. Ensure that all the Doors are closed and that the Shifter is in the Neutral
position.
2. With the Engine already running, apply the Parking Brake and release the
Brake Pedal.
Make sure to release the brake pedal.
3. Within 20 sec. Push lock , unlock or start on the Transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press the trunk button until the system is armed (the doors will be locked if
remote door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will get in Ready Mode.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
Valet Mode
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the
engine from being remote-started accidentally.
To put the system into Valet Mode:
1. Turn the key to the ignition on ( run ) position.
2. Within 3 sec. press the Valet button and release it, the Parking lights will flash 3
times. Turn the
ignition off , the LED will come on . (The system is in Valet Mode.)
To take the system out of Valet Mode:
1. Turn the key to the ignition on ( run ) position.
User Guide P. 5