Bolens 840 thru 849 - Manual (Page 8)

Screws
SEAT ASSEMBLY
Remove the four screws from the bottom of the seat.
Place the seat in position against the seat pivot
bracket, lining up the slotted holes in the pivot bracket
with the holes in the seat. Select desired position for
the seat, and secure with the four screws. See figure
2
.
46" and 50"
Decks Shown
Setting for-
Left Rear Link
Setting for-
Front Links
i
ATTACHING THE DECK LINKS (Hardware A)
The three adjustable deck links have been shipped
unassembled. Attach as follows.
1. Start 1/2" hex nuts on eyebolts provided. Insert
the hex nuts and eyebolts into the adjustable lift
----- links as shown in figure 3.
2. Thread eyebolts into the lift links and hex nuts.
The left rear link should be adjusted so the eyebolt
is to the lower mark as shown. The two front links
should be adjusted to the higher mark.
Hex Bolts
ATTACHING THE CUHING DECK (Hardware B)
1. Working beneath the tractor, remove the round
belt guard from the idler by removing the hairpin
----- clip. See figure 4. Remove the two hex bolts which
act as belt keepers by the engine pulley.
Move the tractor lift handle all the way back to the
full raised position. Turn the tractor steering wheel
all the way to the left.
2 .
FIGURE 4.