Cables to Go TE100-S55 - Manual (Page 54)

54
Appendix G Hardware Specifications
S
WITCH
S
PECIFICATION
• Complies to IEEE 802.3 CSMA/CD 10Base-T, 100Base-TX,
100Base-FX Ethernet Standards
•
Complies to IEEE 802.1d Spanning Tree, IEEE 802.2 LLC,
and ISO 8807-3 standards
• Switched IEEE 802.3 MAC layer frame size: 64-1518
• NWAY Auto-negotiation for each network port providing
auto-detection of connected cable type, auto-sensing of full
or half duplex signaling and auto-configuration
• Store-and-forward packet switching
• Native SNMP management support with Ethernet
MIB II (RFC 1284) and bridge MIB (RFC 1286)
• VLAN support
• 4,096 maximum entries for MAC Address Table
• Comprehensive LED display of the system/port status
• 128KB EEPROM (flash memory) for firmware upgrade
• One RS-232D (DB-9) port for Out-of-Band management
(asynchronous, 8-bit data, 1 stop bit, no parity, 19.2K baud)
• Rack mountable (Fits standard 2U EIA 19” rack)
• Five 10/100Mbps LAN ports built-in
• Optional slot for add-on modules
P ORT S PECIFICATION