Cables to Go TE100-S55 - Manual (Page 24)

24
Upon a successful execution of terminal emulation, your
computer will establish communication with the TE100-S55 and
allow you to view or modify the following settings.
Control Settings System display User selection
Switch
Configuration Switch Version No.
Switch IP Address
Switch Subnet Mask
Default Gateway
Switch MAC Addr.
Save change
Exit V1.10 (Fixed)
168.8.xx.xx
255.255.0.0
0.0.0.0
Factory preset (Fixed)
F2 key
F4 key
Port Configuration Port/x State
Port/x Physical
Port/x State
Port/x Priority Enable (or Disable)
Auto (or 100/Half, 100/Full,
10/Half, 10/Full)
Block, Learning, Listening,
Forwarding, Disable (Fixed)
0 (Hi) - 255 (Low)
Spanning Tree
Configuration Enable / Disable
Bridge (switch) Priority
Root Cost
Hello Time
Forward Delay Time
Max Age Time
Root Bridge
Root Port Enable (or Disable)
32768
(Reflected STA result)
10 sec. (range: 1 - 10 sec.)
30 sec. (range: 4 - 30 sec.)
40 sec. (range: 6 - 40 sec.)
(MAC addr. of Root Bridge)
(Reflected STA result)
Down-load new
system firmware Y / N
Exit Space Key (toggle)
F4 key
Load factory default
parameters Y / N
Exit Space Key (toggle)
F4 key
Filtering Data Base Port Number
Port State
MAC address 1 ~ 5
Disable (or Forwarding,
Blocking)
Up to 16 MAC addresses
Table Chapter 3 -2, TE100-S55 Settings for Out-of-Band management