CNET CNWR-811P - Manual (Page 38)

PC Configuration
35
Macintosh Configuration
The CNWR-811P currently does not support printing from the Macintosh, but you can access
the Internet via the CNWR-811P. The procedure is as follows.
1. Open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field
can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the only change required is to
set the Router Address field to the CNWR-811P's IP Address.
Wireless Configuration
To use the Wireless Access Point in the CNWR-811P, each Wireless Station must have com-
patible settings, as follows:
Mode The mode must be set to Infrastructure.
SSID (ESSID) This must match the value used on the CNWR-811P. The default value is
default
Note! The SSID is case sensitive.
WEP By default, WEP on the CNWR-811P is disabled.
• If WEP remains disabled on the CNWR-811P, all stations must have
WEP disabled.
• If WEP was enabled on the CNWR-811P, each station must use the
same WEP settings as the CNWR-811P.