Bowflex Xtreme 2 SE - Manual (Page 10)

6 Bowflex Xtreme ® 2 SE Assembly Manual
Assembly Guide
step 1 Base Frame Assembly
Parts:
• Base Frame • Right Frame Rail
• Left Frame Rail • Rear Cross Member
Hardware:
• 6 Button Head Screws ( 3/8" X 3/4")
• 6 Flat Washers (3/8")
tool: 7/32" Hex Wrench
1-1 Lay all parts on floor as
shown .
1-2 Insert Frame Rail
connectors into the
Base Frame and
Rear Cross Member .
Secure with screws
and washers as shown .
finger tighten screws
at this time.
step 2 Lower Lat Tower Assembly
Parts:
• Lower Lat Tower Frame
• Rod Box with Power Rod
®
Pack
Hardware:
• 3 Phillips Screws (#10 X 1")
• 3 Flat Washers (1/4")
tool: Phillips Screw Driver
2-1 Lay parts on floor as shown. Firmly
slide Rod Box into Lower Lat Tower
Frame .
2-2 Fasten the Rod Box to the
Lower Lat Tower Frame with
screws and washers as shown .
Tighten screws until snug.
Self Threading
Screws
Flat Washers
Rod Box w/ Rods
Lower Lat Tower Frame
Rear Cross
Member
Right Frame Rail
Button Head Screw
Flat Washer
Flat Washer
Base Frame
Button Head Screw
Left Frame Rail
Button Head Screw
Flat Washer