Adding guest networks, Adding guest networks -21 – NETGEAR wndr3700 User Manual
Page 43
RangeMax™ Dual Band Wireless-N Gigabit Router WNDR3700 User Manual
Safeguarding Your Network
2-21
v1.3, October 2009
•
WPS Settings. For information about WPS settings, see
“Using Push 'N' Connect (WPS) to
Configure Your Wireless Network” on page 2-13
.
•
Restricting access by MAC address. You can use a Wireless Card Access List to restrict
access. See
“Restricting Access by MAC Address” on page 3-2
.
Adding Guest Networks
Adding a guest network allows visitors at your home to use the Internet without having to know
your wireless security key. You can add a guest network to each wireless network, b/g/n 2.4 GHz
or a/n 5 GHz.
To add a guest network, do the following (these instructions shown are for the b/g/n guest network,
but apply to both):
1. Select Guest Network b/g/n from the Setup menu. The Guest Network Settings screen
appears
2. Select any of the following Wireless settings:
–
Enable Guest Network – When this check box is selected, the guest network is enabled,
and guests can connect to your network using the SSID of this profile.
Figure 2-10