NordicTrack CXT 980 831.298651 - Manual (Page 20)

MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the elliptical
crosstrainer regularly. Replace any worn parts immedi­
ately.
For smooth
operation of the
elliptical
crosstrainer, the
incline ramp
should be kept
clean. Using a
soft cloth and
mild detergent,
clean dust and
other residue
from the incline
ramp where the wheels make contact with it. Other
parts of the elliptical crosstrainer can also be cleaned
in this way. Keep liquids off the console. Never use
abrasives or solvents.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the Side Shields (47, 48) and the Pedal Disks
(40) must be removed. Remove the indicated Screws
(72, 88) from both Side Shields and Pedal Disks. Pull
the Pedal Disks out of the Side Shields. Lift the Side
Shields off the elliptical crosstrainer.
Next, locate the Reed Switch (50), Turn the Flywheel
(37) until the Magnet (55) is aligned with the Reed
Switch, Loosen, but do not remove, the indicated
Screw (72). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Rock the
Flywheel forward and back just enough that the
Magnet passes the Reed Switch repeatedly. Repeat
until the console displays correct feedback. When the
Reed Switch is correctly adjusted, reattach the side
shields and the pedal disks.
HOW TO LEVEL THE ELLIPTICAL CROSSTRAINER
If the elliptical
crosstrainer
rocks slightly
during use,
turn one or
both of the
leveling feet
under the rear
stabilizer until
the rocking
motion is elim­
inated.
20