NordicTrack CXT 980 831.298651 - Manual (Page 15)

MOTIVATIONAL TRAINING ZONES
!'.! II i,.i I I l~' I, J I ' '. I
MOIIVATIONAL TRAINING ZONES
fl—I I—1 '—i 1—1 |-^ nn nzi. I—I '
As you exercise, the Training Zone bar will help
you to keep your heart rate near the heart rate
setting for the current segment. The lit indicators
in the bar will show _________________________
your actual pace.
When you hold the
handgrip pulse
sensor (or wear
the optional chest
pulse sensor), the
console will period­
ically compare
your heart rate to
the heart rate set­
ting for the current
segment; if neces­
sary, an indicator in the bar will then flash to
prompt you to increase or decrease your pace to
bring your heart rate closer to the current heart
rate setting. If an indicator to the right of the lit
indicators flashes (see drawing a above),
increase your pace. If an indicator to the left of
any lit indicator flashes (see drawing b), decrease
your pace. When no indicator is flashing, your
heart rate is near the current heart rate setting.
Important; The heart rate settings are intend­
ed only to provide motivation. Your actual
heart rate may be slower than the current
heart rate setting. Make sure to exercise at a
pace that is comfortable for you.
The program will continue until the resistance set­
ting for the last segment is shown in the Current
Segment column of the matrix and the left display
shows that no time remains in the program.
Note: During the program, you can adjust the angle
of the incline ramp with the Ramp Angle buttons. In
addition, you can manually override the resistance
setting for the current segment, if desired, with the
Resistance buttons. However, when the next seg­
ment begins, the resistance will automatically
adjust to the setting for the next segment. If you
stop exercising for six seconds or longer, a tone
will sound and the program will pause.
Watch your progress with the two displays.
Refer to step 5 on page 11.
When the program is finished, the console will
automatically turn off.
See step 7 on page 12.
HOW TO CONNECT YOUR CD PLAYER, VCR,
OR COMPUTER
To use IFIT.com CDs, the elliptical crosstrainer must
be connected to your portable CD player, portable
stereo, home stereo, or computer with CD player. See
pages 15 to 17 for connecting instructions. To use
iFIT.com videocassettes, the elliptical crosstrainer
must be connected to your VCR. See page 17 for con­
necting instructions. To use iFIT.com programs
directly from our Web site, the elliptical crosstrainer
must be connected to your home computer. See page
17 for connecting instructions.
HOW TO CONNECT YOUR PORTABLE CD PLAYER
Note: If your CD player has separate LINE OUT and
PHONES jacks, see instruction A below. If your CD
player has only one Jack, see instruction B.
A. Plug one end of the audio cable into the jack
beneath the console. Plug the other end of the
cable into the LINE OUT jack on your CD player.
Plug your headphones into the PHONES jack.
B. Plug one end of the audio cable into the jack
beneath the console. Plug the other end of the
cable into a 1/8” Y-adapter (available at electronics
stores). Plug the Y-adapter into the PHONES jack
on your CD player. Plug your headphones into the
other side of the Y-adapter,
15