I measure your heart rate if desired – NordicTrack CXT 980 831.298651 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

n o OI
U. ;
TIME
|=J CAIS. DISTANCE
The right
display—The right
display will show
the distance you
have pedaled and
the approximate
number of calories
you have burned. The display will change from
one number to the other every few seconds, as
shown by the indicators. The display will also
show your heart rate when the pulse sensor is
used.
If you stop exercising for several seconds, a tone
will sound and the console will pause.
Note: The console can display speed and distance
in either miles or kilometers. To determine which
unit of measure
ment is selected,
hold down the Start
Program button for
three seconds. An
E for English miles
or an M for metric
kilometers will
appear in the
matrix. To change
the unit of mea
surement, press
the + button (this is the button that also selects
resistance level 10). While an E oran M appears
in the matrix, the left display will show the total
numbers of hours that the elliptical crosstrainer
has been used, and the right display will show the
total number of miles pedaled. When you are fin
ished viewing this information, press the Start
Program button again.
I Measure your heart rate if desired.
Note: if you wear the optionai chest puise sen
sor (see page 19) and hoid the handgrip puise
sensor at the same time, the consoie may not
dispiay your heart rate accurately.
If there are
thin sheets of
plastic on the
metal contacts
on the hand
grip pulse sen
sor, peel off
the plastic. To
measure your
heart rate,
place your hands on the contacts; your palms
must be resting on the contacts closest to you,
and your fingers must be touching the other con
tacts. Avoid moving your hands.
When your pulse is
detected, the heart
rate indicator above
the right display will
light, dashes may
appear in the dis
play, and then your
heart rate will be shown. For the most accurate
heart rate reading, continue holding the contacts
for about 15 seconds. Note: If your heart rate is
not shown, make sure that your hands are posi
tioned as described. Be careful not to move your
hands excessively or to squeeze the metal con
tacts too tightly.
When you hold the pulse sensor, the right display
will show your heart rate for about 15 seconds. If
you continue to hold the pulse sensor, the display
will show your heart rate along with the distance
you have pedaled and the number of calories you
have burned.
I When you are finished exercising, the consoie
I
wiii automaticaiiy turn off.
If the console buttons are not pressed and the
pedals are not moved for a few minutes, the con
sole will automatically turn off.
12