beautypg.com

Storage, Tiller, Fuel system – Poulan HDF550N User Manual

Page 16: Engine oil, Cylinder(s), Engine, Other

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

STORAGE

immediately prepare your tiller for storage at the end of the

season or if the unit will not be used for 30 days or more-

A

WARNING: Never store the tiller with

gasoline in the tank inside a building
where fumes may reach an open flame
or spark. Allow the engine to cool before
storing in any enclosure.

TILLER

Clean entire tiller (See“CLEANING” in the Maintenance

section of this manuai).

inspect and replace belts, If necessary (See belt re­

placement instructions in the Service and Adjustments

section of this manual).

Lubricate as shown in the Maintenance section of this

manual.

Be sure that all nuts, bolts and screws are securely

fastened. Inspect moving parts for damage, breakage

and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand

tightly before painting.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANTTO PREVENTGUM DEPOSITS
FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH

AS THE CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK

DURING STORAGE. ALSO. EXPERIENCE INDICATES THAT

ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING

ETHANOLOR METHANOL) CAN ATTRACTMOISTUREWHICH
LEADSTOSEPARATIONANDFORMATION OF ACIDS DURING
STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM

OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run
until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the

fuel tank or permanent.

Use fresh fuel next season.

NOTE:

Fuel stabiizer is an acceptable alternative in

minimizing the formation of fuel gum deposits during

storage. Add stabilizer to gasoline in fuel tank or storage
container. Always follow the mix ratio found on stabiizer
container. Run engine at least 10 minutes after adding
stabiizer to allow the stabilizer to reach the carburetor.

Do not empty the gas tank and carburetor If using fuel

stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean oil. (See

“ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug.

Pour 1 ounce (29 ml) of oil through spark plug hole into

cylinder.

Puli starter handle slowly several times to distribute

oil.

Replace with new spark plug.

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust.

Rust and/or dirt in your gasoline will cause problems.

If possible, store your unit indoors and cover it to give

protection from dust and dirt.

Cover your unit with a suitable protective cover that

does not retain moisture. Do not use plastic. Plastic
cannot breathe which allows condensation to form and
will cause your unit to rust.

IMPORTANT: NEVER COVER TILLER WHILE ENGINE AND
EXHAUST AREAS ARE STILL WARM.

16

This manual is related to the following products: