Troy-Bilt 14066 - Manual (Page 20)

LC '.-OE. -5SMOVAL AMD iiMSTALLATiOil
REMOVAL OF LOADER
Select a level place to remove loader.
Lower Loader and position Bucket fiat on
ground.
Shut Tractor off and engage parking brake.
Shift Loader Hydraulic Valve into all modes to
completely relieve hydraulic pressure in Loader
Hydraulic Sysem.
Remove Hinge Assemblies.
Start Tractor and adjust Engine Speed to idle.
CAUTION! During Loader removal, Loader
Pressure and Return Hoses must be clear to ex­
tend forward with Loader. Ensure Hydraulic
Hoses are kept in a position to prevent them
from interfering with adjacent Tractor/Mower
components.
Slowly extend Lift Cylinders to raise Subframe
out of Rear Mount.
Slowly back Tractor out of Loader. Extend Lift
Cylinders as necessary to clear front tires.
Note; Loader may need to be lifted off ground
approximately 2” to allow tractor to clear.
When Front Mount contacts Parking Stop, ex­
tend Lift Cylinders until Loader Subframe/Pump
Guard rests firmly on ground.
Shut Tractor off and engage Parking Brake.
Remove Hydraulic Pump retaining hardware and
disengage from Tractor Front PTO.
Position Hydraulic Pump on Loader for storage.
INSTALLATION
Advance Tractor ini', lc .per unt= "ont Mount
contacts Subframe Arms.
Shut Tractor off and ^ ' o ' ’ s park: g brake.
Engage Hydraulic Pp,v Tractor Front PTO.
Start Tractor and adjust Engine Speed to idle.
Retract Lift Cylinders and advance Tractor slow­
ly.
When Front Mount is secure in Retaining Hooks,
retract Lift Cylinders to place Loader Subframe
In Rear Mounts.
Shut Tractor off and engage parking brake.
Shift Loader Hydraulic Valve into all modes to
completely relieve hydraulic pressure in Loader
Hydraulic System.
Install Hinge Assemblies on Loader Subframe.
80-1