Troy-Bilt 14066 - Manual (Page 18)

OPERATION
Unloading
As the tractor approaches the “Unloading
Point”, raise the loader to the height required for
clearance to “Dump” bucket.
Drive slowly to position bucket above
“Unloading Point”, stop tractor and dump
bucket.
Note:
Do not raise loader higher than required for
“Dumping” clearance.
As “Dumping” clearance height increases, the
bucket position must be adjusted to maintain a
level bucket to prevent excessive spillage of
material from bucket.
DANGER. Load on raised bucket can roll
back onto operator area causing severe injury or
death. Load must be kept level.
DANGER. Avoid any overhead wires or
obstacles when loader is raised, to avoid damage
or possible death by electrocution.
Scraping
When scraping, the “Float” position should be
utilized to maintain the bucket firmly on the
ground and at the same time allow the bucket to
follow ground contours.
The bucket should be positioned level to the
ground during “Scraping” operations.
70-4