Troy-Bilt 14066 - Manual (Page 17)

Q P E B A r m k
Loading
Drive straight into pile with the bucket cutting
edge level with the ground, in order to prevent
possibility of damaging tractor or loader -
Do not ram into pile at high speed.
Do not attempt to turn tractor while loading.
As the bucket begins to fill with material,
gradually roll the bucket back and raise the
loader to increase “Fiji” capacity. This pro­
cedure also results in the material being remov­
ed in layers from the top for maximum loading ef­
ficiency.
When the bucket is full, raise loader so that the
bucket is clear of material and slowly back out of
pile.
For maximum loading efficiency, minimize angle
of turn and distance between the Loading and
Unloading points.
Transporting Material
Transporting material to “Unloading Point” wr;h
Loader Bucket as low as possible to prevent
spillage and maintain maximum Tractor/Load:?’'
stability.
Important:
During transport the loader should not be in a
position that will impair operator’s vision.
Observe the following safety messages.
WARNING. A loaded bucket should be
transported in a low position at slow ground
speeds, especially if the ground is irregular.
Make turns slowly and use the tractor brakes
cautiously. A full bucket in the raised position
alters the center of gravity location of the unit
and increases the possibility of mishaps.
A WARNING! Do not lift or carry personnel
on a loader or attachment; a slip or fall could
cause bodily injury.
70-3