To remove chipper-vacuum from carton, Tools required for assembly, Loose parts in carton (see figure 1) – MTD 315B User Manual
Page 4: Attaching the front wheels, Ahaching the nozzle (see figure 3), Assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
FIGURE 2.
Wing Nuts
IMPORTANT: This unit is shipped WITHOUT
GASOLINE or OIL in the engine. After assembiy,
see operation section of this manuai for proper
fuei and engine oil recommendations.
NOTE:
To determine right and left hand sides of your
chipper-vacuum, stand behind and face the unit
(Refer to figure 7).
Your chipper-vacuum has been completely assembled
at the factory except for the front wheels, hub caps,
nozzle, chipper chute, support bracket and bag. A pair
of safety glasses are also included in the carton.
TO REMOVE CHIPPER-VACUUM FROM CARTON
Cut the corner of the carton. Remove ail packing
inserts and loose parts. Push down on handle to lift
front of chipper-vacuum, and roil chipper-vacuum out
of the carton. Make certain ali parts and iiterature
have been removed before the carton is discarded.
TOOLS REQUIRED FOR ASSEMBLY
(1) 3/4" Open End Wrench
(2) 1/2" or Adjustable Wrenches
(1) 9/16" Wrench
(1) Funnel
LOOSE PARTS IN CARTON
(See Figure 1)
(2) Front Wheels
(
1
) Bag
(2) HubCapst
(
1
) Shift Knobt
(1) Nozzle
(
1
) Tamper Plugt
(1) Chipper Chute
(i) Safety Glassesf
(1) Support Bracket
tNot Shown
ATTACHING THE FRONT WHEELS
1
. Tiit unit backward so that it rests on the handle
(place a piece of the carton under handle to avoid
scratches). Remove the cardboard packing
material around the wheel brackets.
2. Remove the hex lock nuts and shoulder bolts
from the front of the wheel brackets. See figure 2.
3. Place wave washer on shoulder bolt. Insert
shoulder bolt through wheel, with the head of the
shoulder bolt through the flat side of the wheel.
4
. Assemble wheel to outside of wheel bracket.
Secure with cupped washer (cupped side of
washer goes against the bracket) and hex lock
nut. Tighten.
5
. Aiign the four tabs on the hub caps with the four
hoies in the wheei. Press in each tab until it locks
in place. The hub cap edges must be flush with
the wheei rim when instailed properly.
AHACHING THE NOZZLE
(See figure 3)
1. Remove the three plastic wing nuts from the front
of the chipper-vacuum. Place the nozzle in posi
tion over the three weld studs. Secure with the
wing nuts just removed.
2. Set unit in upright position.