MTD 24632-8 - Manual (Page 7)

4. Push the release valve down and forward to release
pressure. Cylinder will return, with the aid of two
return springs. See figure 7 and copy of label below.
DOWN TO / '^A UP TO LOCK
RELEASE / / PUMP AND
PRESSURE
^
---
-y SPLIT
— 5 0 5 2
FIGURE 7
CYLINDER RESERVOIR
SCREW AND WASHER
MAINTENANCE
RESERVOIR OIL
1 .
SCREWDRIVER HANDLE
HANDLE
FIGURE 8
Lift the handle on the cylinder mounting assembly
and pull cylinder assembly ail the way back to the
last notch. See figure 8.
2. Remove the pump handle.
3. Release the pressure in the cylinder.
4. Tip the log splitter up so it rests on the wheels and
handle on cylinder assembly. See figure 8.
5. With a standard screwdriver, remove screw and
washer from cylinder reservoir. See figure 8. If oil
is up to hole, do not add any oil. If not, add oil to
bring level up to hole. Oil capacity is 10 fluid
ounces. Nuto H grade 32, or Exxon L.P.
conventional #150 Hydraulic oil.