Operation – MTD 24632-8 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. Lift the handle socket up so that the hole lines up
_ with the hole in plunger shaft. See figure 4.
6. Secure handle socket to plunger shaft with hair pin
(C) and clevis pin (D). See figure 4.
7. Place the handle grip (A) over one end of handle
(B). Warm soapy water will aid in assembly. Tap
grip on.
8. Place handle over handle socket.
FIGURE 4
HANDLE ON
CYLINDER MOUNTING
ASSEMBLY
OPERATION
This 8 ton capacity hydraulic unit is a special design,
manufactured for use on this log splitter only.
1. This splitter can be adjusted manually for logs 8"
to 24" long. There are twelve different settings.
Settings are approximately 1-1/2" apart. See,
figure 5.
2.
Simply lift up on handle of cylinder mounting
assembly and slide the unit forward or backward
for the correct log length. See figure 5.
FIGURE 5
3. Pull the release valve up and back to lock. Then
handle can be pumped to split logs. See figure 6.