MTD 24632-8 - Manual (Page 5)

t ♦
ASSEMBLY INSTRUCTIONS
CONTENTS OF HARDWARE PACK AND LOOSE
- PARTS: (See Figure 1)
A (1) Handle Grip
B (1) Handle
C (1) Hairpin Cotter (may be rings)
D (1) Clevis Pin (may be pin)
E (1) Axle
F (2) Push on caps 1/2" Dia.
G (2) Spacers
H (2) Wheels
FIGURE 1
WELDED TUBE
WHEEL (H)
\
1 .
2 .
3.
Remove the log splitter, loose parts and literature
from carton. Check to be sure all parts are removed
from carton before discarding the carton.
Place the axle (E) through the welded tube on
splitter. See figure 2.
Next, place spacers (G) on each side of splitter,
over axle. See figure 2.
PUSH ON CAP (F)
figure 2
USE A SECOND
HAMMER, OR BLOCK
OF WOOD
4.
5.
Next, place wheels (H) over each end of axla
See figure 3.
Secure wheels to axle with push on caps (F). A
hammer and block of wood will be required to
hammer on the caps. See figures 2 and 3.
HAMMER
FIGURE 3
5