Assembly instructions – MTD 241-645A User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOOLS REQUIRED:

(1) Raw Hide or Plastic Hammer

(1) 1-1/8" Wrench or Adjustable Wrench

(1) 3/4" Wrench

OTHER MATERIALS NEEDED:

(A) One gallons of regular grade gasoline (for engine)

(B) 1-1/2 pints of SAE 30 or 10W oil (for engine)

(C)

Approximately 3 gallons of Dexron II automatic

transmission fluid. (May be obtained at your

local service station or auto parts store).

(E) Automotive Grease

(F) Funnel

___________ F

»iiSliiiliil

FIGURE 1

ASSEMBLY INSTRUCTIONS

1. Pack the tapered roller bearings with automotive

grease.

NOTE

Do Not put any grease in the hub caps.

2. Place one spacer (A) on axle, next one wheel, and

tapered roller bearing (B). See figure 2.

LIST OF CONTENTS IN HARDWARE PACK:

See figure 1.

(A) (2) Spacers

(B) (2) Tapered Roller Bearings

(D) (2) Cotter Pins

(E) (2) Hub Caps

(F) (I) Shoulder Bolt

(G) (I) Flat Washer

FIGURE 2