Generac Power Systems 00802-3 - Manual (Page 32)

INSTALLATION CHECK LIST
LOCATION AND SUPPORT EXHAUST SYSTEM
_1. The generator is properly located.
_2. The generator is properly supported.
_3. The generator is properly restrained.
___ 1. Complies with code requirements.
___ 2. Properly and safely installed.
ELECTRICAL CONNECTIONS
COMPARTMENT
___ 1. Compartment construction is proper.
___ 2. Holes/openings are vapor-sealed.
___ 3. Compartment size is correct.
___4. Compartment is vapor-sealed.
___ 5. Sound insulation is O.K.
___ 6. Floor cutouts properly completed.
COOLING and VENTILATING AIR
___ 1. Air flow is adequate.
___ 2. Air inlet opening is correct.
___ 3. Compensate for restrictions
4. Installation has been tested
___ 1. Comply with code requirements.
___ 2. Junction box properly installed.
___ 3. Wiring meets all standards.
___ 4. All connections are correct.
___ 5. Conduit properly installed and sealed.
___ 6. Generator properly bonded to vehicle.
BATTERY INSTALLATION
___ 1. Recommended battery is installed.
___ 2. Recommended cables are installed.
___ 3. Cables are clean and tight.
___ 4. Cables are properly connected.
___ 5. Proper ventilation is provided.
POST INSTALLATION TESTS
___ 1. All tests properly completed.
GASOLINE FUEL SYSTEM
___ 1. Fuel tank complies with code.
___ 2. Fuel system properly installed.
OPTIONS AND ACCESSORIES
Check that remote start/stop panels (if used) are prop­
erly installed.
If an hourmeter kit is installed, check that job was done
properly.
If any other options and accessories are installed,
check that they were installed properly.
DATE OF INSTALLATION
NAME OF INSTALLER
SIGNATURE OF INSTALLER
—
30
—