Assembly instructions, Figures – MTD 249-645A User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY INSTRUCTIONS

J. Pack the tapered roller bearings with automotive

grease.

NOTE

Do Not put any grease in the hub caps.

2. Place one spacer (A) on axle, next one wheel, and

tapered roller bearing (B). See figure 3.

TAPERED

ROLLER
BEARING (B)

FIGURES

Thread hex castle nut (C) on axle. Tighten castle
nut until snug, back off approsimately 1/3 turn

or until one of the slots on the castle nut lines up

with hole in axle. Secure castle nut to axle with
cotter pin (D).See figure 4.

FIGURE 4

4. Place hub cap (E) in position on wheel and tap on

with a plastic hammer. See figure 5.

FIGURES