MTD 1850 - Manual (Page 6)

Step 3. Screw the control rod into the ferrule until it
extends through the ferrule % of an inch.
Refer to Figure 1-5.
FIGURE 1-5. FERRULE ADJUSTMENT
Refer to Figure 1-6.
Step 4. Place the bent end of control rod into the
control lever and fasten with cotter hairpin N.
Step 1. Push the black plastic knob on the throttle
control all the way.
Step 2. Pull out the black knob until the detent
clicks twice to allow the spring lockwasher
and the hex nut to pass over the detent
boll to the threads.
Step 3. Slide the spring lockwasher and the hex nut
over the detent ball and thread the hex nut
one or two turns.
Step 4. Place the conduit through the slot in the
handle pandl.
Step 5. Push the throttle control in until it seats.
Step 6. Tighten the hex nut.
e. Throttle Control Assembly
FIGURE 1-6. CONTROL ASSEMBLY
1-3