C. handle assembly, B. depth bar, D. control assembly – MTD 1850 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

FIGURE 1-1. WHEEL ASSEMBLY

Refer to Figure 1-2.

Step 3. Place the wheel hanger into the tailpiece and

secure with clevis pin D and locking pin E.

c. Handle Assembly

Refer to Figure 1-3.

Assemble the handle to the handle bracket with 4

hex bolts G, lockwashers I and hex nuts H.

FIGURE 1-3 HANDLE ASSEMBLY

Depth Bar

Refer to Figure 1-2.

Step 1. Attach the depth bar to the tailpiece with the

clevis pin.

Step 2. Secure the clevis pin F with the locking pin E.

d. Control Assembly

Refer to Figure 1-4.

Step

Place

the

control

lever

through

the

handle

assembly.

Step 2. Attach at the bottom with hex bolt J, steel

washer K, rubber washer L and secure with
hex nut M.

FIGURE 1-2. WHEEL HANGER AND DEPTH BAR