Muffler, Spark plug, Transmission – Poulan 156335 User Manual

Page 15: Cleaning, Tiller, To adjust handle height (see fig. 22), Tire care, To remove wheel (see fig. 23), Customer responsibilities, Service

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CUSTOMER RESPONSIBILITIES

MUFFLER

Do not operate tiller without, muffler. Do not tamper with

exhaust system. Damaged mufflers or spark arresters

could create afire hazard. Inspect periodically and replace

if necessary. If youn:engine is equipped with a spark

arrester screen ..assembly, remove every 50 hours for
cleaning and inspection. Replace if damaged.

SPARK PLUG

Replace spark piugs at the beginning of each tilling season

oraftenbverySOhoursof use, whichevercomesfirsi. Spark

plug type and gap setting is shown in “PRODUCT SPECl-
FtCATiONS” on page 3 of this manual.

TRANSMISSION

Yourtransmission is sealed and will .only regiiife lubrication

if serviced'........................

CLEANING

•

Clean engine, wheels, finish, etc. of all foreign matter.

“ Keep finished surfaces and wheels free of all gasoline,

oil, etc.

Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose to clean your

unit unless the muffler, air filter and carburetor are covered

to keep water out. Water in engine can result in a shortened

engine life.

SERVICE

AND

ADJUSTMENTS

CAUTION: Disconitect spark plug wire from spark plug and place wire where It cannot come into
contact with plug.

TILLER

TO ADJUST HANDLE HEIGHT (See Fig.

22)

Select handle height best suited for your tilling conditions.
Handle height will be different when tiller digs Into soil.

« First loosen handle lock lever.

» Handle can be positioned at different settings between

“HIGH" and “LOW” positions.

» Retighten handle lock lever securely after adjusting.

TIRE CARE

CAUTION: When mounting tires, un
less beads are seated, overinflation

can cause an explosion.

Maintain 20 PS! (1.4 kg/cm^) of tire pressure. If tire
pressures are not equal, tilier will pui! to one side.

® Keep tires free of gasoline or oil which can damage

rubber.

TO REMOVE WHEEL (See Fig. 23)

« Place blocks under transmission to keep tiller from

tipping.

® Remove hairpin clip and clevis pin from wheel.

» Remove wheel and tire.

Repair tire and reassemble.

CLEVIS PIN

HAIRPIN CLIP

FIG. 23