Poulan XC1182B - Manual (Page 9)

ASSEMBLY
INSTALL MOWER (See
FIGS. 5, 6, 7 & 8)
Your unit has been shipped with the mower parallel link in­
cluded in the parts carton. Install mower parallel link on unit
using short hinge pin and retainer spring.
NOTE: Smaller end of parallel link mounts to tractor. Use the
shortest hinge pin for mounting.
Raise attachment lift lever to its highest position.
Remove banding from suspension arms.
Slide mower under tractor with discharge guard to right
side of tractor.
Attach front of mower to parallel link with long hinge pin.
Secure hinge pin with retainer spring.
Turn height adjustment knob to its lowest setting.
Lower attachment lift lever to lower suspension arms. Re­
move retainer springs from lift trunnions.
Slide trunnions through upper lift bracket holes and se­
cure with retainer springs.
Pull L.H. idler pulley toward the right hand side of tractor
and roll belt over electric dutch pulley.
NOTE: Mower drive belt installation decal located on mower
housing.
• Raise attachment lift lever to raise mower.
• Turn height adjustment knob clockwise to the middle of its
travel.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled. See “TO LEVEL MOWER HOUSING” in the Serv­
ice and Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion, mower
drive, and mower blade drive belts in the Service and Adjust­
ments section of this manual. Verify that the belts are routed
correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see that
the brake is properly adjusted. See “TO ADJUST BRAKE” in
the Service and Adjustments section of this manual.