Poulan XC1182B - Manual (Page 22)

SERVICE AND ADJUSTMENTS
TO REPLACE MOTION DRIVE BELT (See
FiG. 32)
Park the tractor on level surface. Engage parking brake. For
ease of service there is a belt installation guide decal on bot­
tom side of left footrest.
• Remove mower (See “TO REMOVE MOWER" in this sec­
tion of this manual).
• Remove the clutch locator.
• Loosen bolt securing R.H. belt keeper.
• Disconnect dutch wire harness.
• Puli belt off clutching idler and raise to top side of pulley.
• Release parking brake. Push belt over and away from
clutching idler.
» Pull belt slack toward rear of tractor. Remove belt from
transmission pulley by deflecting keepers to force belt up
and out of pulley. Use belt to push keepers away from pul­
ley.
• Work belt around remaining pulleys and keepers, working
toward transaxle pulley.
• Pull belt forward off of transaxle pulley and down over
electric clutch.
» Install new belt by reversing above procedure.
IMPORTANT: MAKE SURE RIGHT HAND BELT KEEP­
ER IS POSITIONED CORRECTLY BE­
TWEEN LOCATOR TABS, AND ELEC­
TRIC CLUTCH CONNECTION IS SE­
CURE.
TRANSAXLE SHIFTER LINKAGE AND
ADJUSTMENT (See FIGS. 33 and 34)
The transaxle should be in neutral when the gear shift lever
is in the neutral (lock gate) position. The adjustment is preset
at the factory: however, if adjustment is needed, proceed as
follows.
• Make sure transaxle is in neutral.
® Loosen two locknuts on tie rod.
FIG. 33
Turn center rod until gearshift lever falls into neutral lock
gate on fender console.
• Tighten locknuts securely
TO ADJUST STEERir-G WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer­
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE--iN/CAMBRR
The front wheel toe-in and camber are not adjustable on
your unit, if damage has occurred to affect the front wheel
toe-in or camber, contact your nearest authorized service
center.