beautypg.com

Off-season storage, Optional equipment, Trouble shooting – MTD 241-675-000 User Manual

Page 9: Troubie shooting

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

\

OFF-SEASON STORAGE

The following steps should be taken to prepare your
vacuum for storage.

1. Clean and lubricate the vacuum thoroughly as

described in the lubrication instructions.

2. Refer to engine manual for correct engine storage

instructions.

3. If storing in an unventilated or metal storage shed,

coat metal parts with a light oil or silicone to pre­
vent rust.

4. Store in a dry, clean area.

OPTIONAL EQUIPMENT

Hose Attachment Kit Model 290-204-000 is available
as optional equipment. See figure 21.

Hose

Attachment

Kit

FIGURE 21.

TROUBLE SHOOTING

PROBLEM

POSSIBLE CAUSE(S)

CORRECTIVE ACTION

Engine fails to start

1. Fuel tank empty, or stale fuel.

2. Spark plug wire disconnected.

3. Faulty spark plug.

1. Fill tank with clean, fresh fuel.

2. Connect wire to spark plug.

3.

Clean, adjust gap or replace.

Loss of power;

operation erratic

1. Spark plug wire loose.

2. Unit running on CHOKE.

3.

Blocked fuel line or stale fuel.

4. Water or dirt in fuel system.

5.

Carburetor out of adjustment.

6. Dirty air cleaner.

1. Connect and tighten spark plug wire.

2. Move choke lever to OFF position.

3.

Clean fuel line; fill tank with clean

fresh gasoline.

4. Disconnect fuel line at carburetor to drain fuel

tank. Refill with fresh fuel.

5.

Adjust carburetor.f

Engine overheats

1. Carburetor not adjusted

properly.

2. Engine oil level low.

1

. Adjust carburetor.f

2. Fill crankcase with proper oil.

Too much vibration

Loose parts or damaged

crankshaft.

Stop engine immediately and disconnect

spark plug wire. Tighten all bolts and nuts.

Make all necessary repairs. If vibration continues,

have unit serviced by an authorized service
dealer.

Unit does not

discharge

1. Directional discharge clogged.

2. Foreign object lodged in vane

plate.

3.

Belt worn and/or stretched.

1. Stop engine immediately and disconnect

spark plug wire. Clean directional discharge.

2. Stop engine immediately and disconnect

spark plug wire. Remove lodged object.

3.

Replace belt. See maintenance section of

this manual.

tRefer to the engine manual packed with your unit.
NOTE: For repairs beyond the minor adjustments listed above, please contact your nearest authorized service dealer.

This manual is related to the following products: