Installation of optional tow bar, Operation, Before starting engine – MTD 241-675-000 User Manual
Page 6: To start engine
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hand Knob
FIGURE 14.
Hex Nut
(W)
Hex
Bolt (U)
Truss
Machine
Screw (X)^
Directional
Discharc e
Assembly (R)
Belleville
Washer (AB)
Hex Je m
Lock N ut
(AC)
hlitch
Plate
Shoulder
Spacers (V)
FIGURE 15.
Lock
Washer (Y)'
Hex
Nut (Z)
Shoulder
Bolt (AA) /
Belleville
Washer (AB)
4. Lift up and out on the housing and rotate it 105°
clockwise. Chute opening should be to the right
hand side when viewed from the front of unit. See
-----figure 13.
5. Place the impeller guard (S) into flanges on front
of housing. Line up hole In guard with hole on
housing. Secure with one hand knob and belleville
washer. See figure 13.
Place the directional discharge assembly (R) over
chute opening. Secure with two hand knobs and
-belleville washers. See figure 14.
INSTALLATION OF OPTIONAL TOW BAR
1. Remove the self-tapping screws on each side of
frame. Refer to illustration on page 10, reference
number 42.
2. Place one bar half in position on frame of vacuum.
Place one shoulder spacer (V) between frame and
tow bar. Next, place shoulder spacer (V) and hex
bolt (U) through tow bar and frame. Secure with
hex nut (W). See figure 15. Repeat on other side.
3. Secure the two tow bar ends together with truss
machine screw (X), lock washer (Y) and hex nut
-------(Z). See figure 15.
To attach the tow bar to a hitch, place the shoulder bolt
(AA) up through the tow bar. Place one belleville washer
(AB) on the shoulder bolt, then the hitch plate and the
other belleville washer. Cupped side of the washers
must be against the hitch plate. Secure with hex jam
lock nut (AC). See figure 15.
OPERATION
BEFORE STARTING ENGINE
Service engine with gas and oil.
See engine m anual
packed with vacuum for complete instructions fo care
and maintenance of engine.
Read directions
carefuliy.
A
WARNiNG: Revoiving blades — keep
hands away from all openings.
TO START ENGINE
After the engine has been properly fueled and oiled
(refer to engine operating and maintenance instruc
tions), start engine as follows.
1. Move choke lever on engine to CHOKE position.
A warm engine may not require choking.
2. Move throttle control lever on engine to FAST
position.