Attaching the upper handle, Attaching the air duct assembly, Installing the bag – MTD 241-675-000 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Upper
Handle (O)
ATTACHING THE UPPER HANDLE
Place the upper handle (O) in position over lower
handle. Fasten with four hex bolts (I) and lock nuts (J)
-provided. See figure 5. Two 7/16" wrenches are re
quired.
Hand
Knob (F)
^Belleville^/^\
asher
ATTACHING THE AIR DUCT ASSEMBLY
Place air duct assembly (P) over opening on top of
housing. Secure with two hand knobs (F) and belleville
washers (G) (cupped side of washers against the air
-duct assembly). See figure 6.
FIGURE 6.
INSTALLING THE BAG
1. Place the stud pins (K) in holes in upper handle
(head of pins go to the inside of handle). Secure
pins with push-on speed nuts (L) by holding speed
nut with box wrench and tapping pin with hammer.
------ See figure 7.
FIGURE 7.
r)
Stud P n
ji
On Handle
2. Assemble the bag by slipping the top straps on bag
(T) over upper handle. Hook two small straps over
stud pins on handle. Slip elastic opening of bag
over air duct assembly. Be certain elastic on bag
is placed over the flanges on air duct assembly.
—See figure 8.
Bag (T)
FIGURE 8.